New setup that i shall be using for acromyrmex. I have designed it in a way that all the heating is contained within the setup. the fungus chamber on the far right, and it is the smaller chamber inside of the larger one. The larger one acts as an incubator. You fill the bottom with water and underneath place a heatmat or place a heater inside. Then, the fungus grows inside the smaller cube as seen in the picture. This maintains a high humidity and perfect temperature.
This is just a rough sketch i made. Actual design will show the detailed nest.
![Image](http://i393.photobucket.com/albums/pp13/Formica_Ants/nbgngbg_zpstqtulyt6.png)
All will be made out of acrylic, 5mm thick. Boxes are 25x25x25cm and fungus chamber 18x18x18 , maybe even 20x20x20cm.
Pipe is 32mm inner diameter